
Reaction vessels, autoclaves & hydrogenators
Agitated reactors and autoclaves from pilot scale to 90 kL, with jackets, limpet coils or internal coils, in stainless steel, high alloys and explosion-bonded clad.
Pre-fermenters, fermenters, cGMP reaction vessels and pilot-scale vessels with mirror-polished and electropolished finishes.
What we build under this heading, with the page and the detailed enquiry form for each type.

Agitated reactors and autoclaves from pilot scale to 90 kL, with jackets, limpet coils or internal coils, in stainless steel, high alloys and explosion-bonded clad.

Pressure filters for solid–liquid separation, with polished contact parts and designs that discharge cleanly and clean easily.
Illustration, not to scale
Inside a reaction vessel
A limpet-coil reactor with a top-entry agitator, part by part. Jacketed, half-pipe and internal-coil designs, hydrogenators and autoclaves follow the same logic.
Scroll to open it up.
Pressure envelope01 / 05
Heat transfer02 / 05
Agitation03 / 05
Seal and drive04 / 05
The whole reactor05 / 05
Reactors, hydrogenators, autoclaves and pressure vessels are built in the same works, to the codes your project specifies.
For engineers who check: open a panel for the detail behind each claim.
ASME BPVC Section VIII Div. 1 & 2 with U stamp and National Board registration, EN 13445, PD 5500, TEMA, API 650, IS 803, AD 2000-Merkblatt with HP0, PED 2014/68/EU (Annex I 3.1, Module A2 under CE 0045, Module G), ATEX 2014/34/EU and IBR 1950.
Drainability and dead zones, sight and light glasses, sampling points, CIP and changeover needs reviewed at drawing stage; grinding, buffing, polishing, pickling and passivation in-house, electropolishing as a specialized process; Ra measured and recorded in the dossier.
Stainless steels including 304L, 316L, 316Ti and 904L; duplex, super-duplex and hyper-duplex; Hastelloy C-276, C-22 and C-2000; Inconel, Incoloy, Monel, Alloy 20, Sanicro 28 and nickel; carbon and low-alloy steels — in solid or explosion-bonded clad construction, and many more related grades.
Approved ITP and QAP; stage inspection by third-party agencies; RT, UT, PT, MT and VT by in-house ASME NDE Level II personnel; PMI on every finished item; hydrostatic or pneumatic testing; a complete dossier with material traceability.
Detailed references are available on request.
See all project examples →Send the datasheet or drawing — the RFQ form arrives with this solution already selected.
No datasheet yet? Enter the design data you have, section by section, and we will work out the rest.
Technical enquiry form